HEWLETT PACKARD (HP) HP1653B VOLUME 1
Manual de Usuario

Disconnecting the Probes from the Pods

When you receive the logic analyzer,the probes are already installed in the pods. To keep them out of your way, disconnect them from the pod.

To disconnect a probe, insert the tip of a ball-point pen into the latch opening. Push on the latch while gently pulling the probe out of the pod connector as shown below.

0166OEll

Figure 2-8. Disconnecting Probes From Pods You connect the probes to the pods by inserting the double pin end of the probe into the pod. The probes and pod connector body are both keyed (beveled) so that they will fit together only one way.

HP 16528/1653B

Probing
2-11